> For the complete documentation index, see [llms.txt](https://promega.printm3d.com/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://promega.printm3d.com/repair-and-maintenance/install-uninstall/limit-switch-holder/untitled.md).

# X Axis

## What is the X Limit Switch Holder?

This is the X Limit Switch Holder.

![](/files/-LQ6C01sHAq9oklkhVTp)

## Warning

Exercise caution if you attempt to fit your head underneath the bed. The frame could potentially cause lacerations.  

* Use protective headgear (e.g. tear-resistant fabric).
* Enter slowly. Do not rush. 
* Make sure the bed is properly positioned.

## Tools

* T10 Screwdriver

## Additional Hardware

* ***None***

## How To Uninstall

Run:

```
M18 Z
```

This disables the Z motor. Lower the bed until it touches the Z limit switch.

Remove the Limit Switch from the holder:

![](/files/-LPRVnRULmIWkifsnmga)

Unscrew the X Limit Switch Holder (printed part):

![](/files/-LPRVpymVAnRp2H_-AYU)

## How To Install

Screw down the X Limit Switch:

![](/files/-LPRVpymVAnRp2H_-AYU)

Slide the Limit Switch into the X Limit Switch Holder (printed part):

![](/files/-LPRWjepwANpetWYpzU8)

Done.